CAN030 is the final in our spray can series. This PSD Mockup renders your early stage sketches or finalized can design onto an 85g (3oz) spray can with plastic cap (non-removable in this composition). The design is made to look like it is printed on the paper label which surrounds the body of the can. (more…)

CAN037 renders a common spray can with your design applied to the label wrapped around its surface. This PSD Mockup represents a quarter-height can, one of the smaller cans in this category. The most popular use for this type of container is for shaving cream, paint spray, hair spray or low tack spray adhesive product. (more…)

CAN035 is a typical spray can with plastic cap. This PSD Mockup renders your supplied sketch or finalized designs onto a standing 213g (~8oz) spray can. The completed render will present your artwork on a can with a 30° view from above the can looking down. The samples included in this post make it seem the can is facing forward, however, you can easily render the side (more…)

CAN034 applies the supplied sketch or final designs to a standing proxy spray can with a 45° downward view. This PSD Mockup simulates a 340g (approx 12oz) spray can facing forward with light reflections placed on either side. To make the can appear as if it was rotated to the left or right, simply offset your artwork in the template so that it is not perfectly centered. (more…)

CAN033 is a standing 340g (12 ounce) spray can with plastic lid. This PSD Mockup renders your spray can design onto the can which is facing forward. The view angle of the can is with a small downward view allowing the top of the can to be visible. A worms eye view of the same 12 ounce PSD mockup can be found here. (more…)